|
Important Note : Never Test Pumpset In Dry condition. Pure Water Must completely Be Filled In Motor & Casing Of Pump Before Testing, Testing Period Must Not Exceed 15 Seconds. Even For Testing of Motor Only, Water Must Be Filled In It Before Testing. During Testing Period, Water Must Continuously Be Poured On Oil Seal Of Motor. To Check Alignment Of Complete Pumpset, Move Shaft Assembly By A Screw Driver Upward-Downward. The Shaft Assembly Will Lift 1 to 2mm When Alignment Is Proper. All Precautionary Measures As Specified In Given Manual, Must Be Adhered Carefully.
T68 Series - Submersible Pumpsets Are Suitable Fore Borewell of Minimum 8" (200mm) or Bigger Size. Maximum Outer Diameter of Pumpsets is 182mm. The Pumpsets Comprise Heavy Duty Motor of 6" (150mm) & Pump of 8" (200mm).
All Above Models Are 3-Phase, 350/440 Volts, 2820/2880 RPM, 50 Hz & 2 Poles.
7.5 HP Submersible Pumpsets With SD = ) (Delta Connection) (Double Cable) Can Also Be Made Available.
|
